生料粉磨系统的节能改造

doi:10.19698/j.cnki.1001-6171.20214050

摘要
相关文章
推荐阅读
Metrics

下载:

PDF (2239KB)
输出: BibTeX | EndNote (RIS)

摘要介绍了生料粉磨系统由辊磨系统改为辊压机终粉磨系统的情况。新粉磨系统在V型选粉机前加装了密封喂料机，选用了高效节能风机，将收集成品的旋风筒改为2个，将气动闸板阀改为气动棒阀，采用永磁电机驱动。改造后，生料粉磨系统产量从430t/h提高到500t/h以上，系统电耗从15.7kW·h/t降至10.8kW·h/t。

	服务
	把本文推荐给朋友
	加入引用管理器
	E-mail Alert
	RSS
	（）
	作者相关文章
	张松立

关键词: 生料粉磨辊压机辊磨

Abstract: The situation of the raw meal grinding system being changed from the original roller grinding system to the final grinding system of the roller press is introduced. The new grinding system is equipped with a sealed feeder in front of the V-type powder separator, and a high-efficiency energy-saving fan is selected. The cyclone for collecting the finished product is changed to two, and the pneumatic gate valve is changed to a pneumatic rod valve, which uses permanent magnets motor for driving. After the transformation, the output of the raw meal grinding system was increased from 430t/h to more than 500t/h, and the power consumption of the system was reduced from 15.7kW·h/t to 10.8kW·h/t.

Key words: raw meal grinding roller press roller mill

收稿日期: 2021-04-06 出版日期: 2021-07-25 发布日期: 2021-07-21 整期出版日期: 2021-07-25

ZTFLH:

TQ172.639

引用本文:

张松立. 生料粉磨系统的节能改造[J]. 水泥技术, 2021, 1(4): 50-53.
ZHANG Songli. Energy-saving Reformation of Raw Meal Grinding System. Cement Technology, 2021, 1(4): 50-53.

链接本文:

http://www.cemteck.com/CN/10.19698/j.cnki.1001-6171.20214050 或 http://www.cemteck.com/CN/Y2021/V1/I4/50

[1]	石国平, 秦中华, 王明治, 柴星腾, 李铭哲. 大规格生料辊压机终粉磨系统的工业应用[J]. 水泥技术, 2021, 1(5): 15-20.
[2]	荣亚坤, 陈作炳, 薄文帅, 霍守华, 张书凯. 大型辊磨圆锥滚子轴承受力分析与疲劳寿命计算[J]. 水泥技术, 2021, 1(5): 21-27.
[3]	段文虎, 刘章名. 生料辊压机终粉磨系统智能控制方案的优化[J]. 水泥技术, 2021, 1(5): 51-54.
[4]	秦学恒. RP1712辊压机断螺栓故障分析及处置[J]. 水泥技术, 2021, 1(4): 73-79.
[5]	徐小定, 丁成坤, 李光增. LMY辊磨在循环流化床锅炉两级脱硫制粉系统中的应用[J]. 水泥技术, 2021, 1(3): 45-48.
[6]	王飞, 康宇, 钟根, 钟永超. KVM外循环水泥辊磨半终粉磨系统及其应用 [J]. 水泥技术, 2021, 1(2): 23-25.
[7]	沈锡荣, 顾云涛. 双曲线进料装置在辊压机系统循环负荷精准控制中的应用 [J]. 水泥技术, 2021, 1(2): 33-36.
[8]	李永强. ATOX辊磨磨辊润滑系统的使用与维护 [J]. 水泥技术, 2021, 1(2): 37-40.
[9]	邢愚, 戴建盛, 楼美善. 降低水泥粉磨电耗的改造实践 [J]. 水泥技术, 2021, 1(2): 97-99.
[10]	刘迪, 王维莉, 刘畅, 聂文海, 赵剑波. 国产TRMS4531镍渣辊磨的应用 [J]. 水泥技术, 2021, 1(1): 17-20.
[11]	许帅. 水泥辊磨油站通讯故障的处理 [J]. 水泥技术, 2021, 1(1): 84-85.
[12]	韩仲琦, 马占海. 料床粉磨与颗粒学[J]. 水泥技术, 2020, 1(6): 75-80.
[13]	张高科. 熟料温度对水泥辊磨运行的影响及解决措施 [J]. 水泥技术, 2020, 1(6): 90-91.
[14]	孔金山, 李光业. LM型立式辊磨机在循环流化床锅炉脱硫系统中的应用 [J]. 水泥技术, 2020, 1(5): 46-49.
[15]	黄贺. 三维图像识别成形技术在辊压机辊面监测上的应用 [J]. 水泥技术, 2020, 1(5): 71-73.

[1]	. Review and Prospect of Engineering Practice of Waste Disposal in Cement Kiln in China[J]. Cement Technology, 2018, 1(1): 17 -21 .
[2]	DI Dongren, TAO Congxi, CHAI Xingteng. Revision of Cement Energy Consumption Standards and Energy Saving Technology(Ⅰ)[J]. Cement Technology, 2018, 1(1): 22 -26 .
[3]	LIU Yonggang, GAO Hongwei, XIAO Guiqing. Design Method of Road Structure Using Lean Concrete Base[J]. Cement Technology, 2018, 1(1): 27 -31 .
[4]	LIU Xu, LI Liang. Investigation of New Medium Temperature Wear-resistant Alloy Steel[J]. Cement Technology, 2018, 1(1): 32 -34 .
[5]	MA Debao. Finite Element Analysis of Inverted Cone in Raw Meal Silo[J]. Cement Technology, 2018, 1(1): 35 -38 .
[6]	HAN Zhongqi. [J]. Cement Technology, 2018, 1(1): 38 -48 .
[7]	XIE Jianzhong, LIAN Xuewen. Analysis and Solution of Segregation of the Kiln Ash in Continuous Raw Meal Homogenization Silo#br#[J]. Cement Technology, 2018, 1(1): 49 -53 .
[8]	GUAN Laiqing, HE Yongxian. [J]. Cement Technology, 2018, 1(1): 54 -59 .
[9]	WEI Can, ZHANG Yuanyuan, AI Jun. Application of Cement Intelligent Control System in Overseas Projects[J]. Cement Technology, 2018, 1(1): 60 -64 .
[10]	JIN Shuang. [J]. Cement Technology, 2018, 1(1): 72 -73 .

Viewed

Full text

Abstract

Cited

Shared

Discussed